2 - Indoor
Three 1.5V AA batteries. Battery life: approximately 18 months with standard use. Battery life significantly decreases in busy areas and with extensive use of the camera.
The device reports when it is being opened and detached from the wall.
EU compliant Dual Band frequency operations. Range is suitable for device’s intended use. Data (video frames) transmission over 2,4GHz Wi-Fi.
Monitoring and Testing
Tamper alarm is triggered by sliding the device off its bracket. By triggering tamper alarm, you also enable TEST mode for 3 minutes to allow PIR range tests without PIR operations locking out after the first alarm. Alarm Keep the front cover of the housing open to permanently enabled the device’s TEST
mode. Test camera’s operation by switching on the camera, simulating an alarm and verifying that images are properly received. We recommend to temporarily disable sirens before testing.
The PIR section of the device operates as other similar devices being offered in this catalogue, but this item allows you to preenable/ disable the camera by sending radio commands from the control panel (when used within an alarm system) or from a special remote control (when used as a stand-alone device). When enabled by either means, the camera takes 640X480 pixels (VGA) video frames only after motion detection (PIR) alarm is triggered. As part of an alarm system the camera sends the pictures to a Silenya HT control panel as MMS or as e-mails to the preset addresses. As a stand-alone device, frames are placed in the local network over the Access- Point.
Video frames on demand:
remote commands are available to receive video frames on demand with both kinds of installations. In order to receive frames on demand when PhotoPir is used as a stand-alone, it must be always powered using an Access-Point standard 5V power supply fitted with a mini-USB port. Caution: video frames transmission is assured also with power failure only when the device is used within a Silentron alarm system.
PhotoPir offers an alarm/test LED indicator. 5 consecutive beeps will sound after each alarm transmission to locally report that batteries need to be replaced.