5519 Glass-Break Detector

Glass-Break Detector

This device is built to report the breaking of glass in a room.

Volumetric protection through a microphone in rooms sized approximately 6x4m or smaller.

The lack of limitations due to wiring is useful to appropriately position the device which is of paramount importance for it to properly operate. The device must be wall mounted at a least a 2 m height facing the wall where most windows are located.

Size (h×l×d)
80×108×43 mm

0.16 Kg

Environmental class
2 - Indoor


Power Supply
9V 6LR61 alkaline battery. Battery life: approximately two years with standard use.

Tamper protection
This produces a signal when the device is opened.

Radio transmission
EU compliant Dual Band operations. Range is suitable for device’s intended use.

Monitoring and Testing
A simple clap of the hands causes the LED to switch on to prove that the device is active and functioning.
Warning: this does not cause the actual alarm: if wanting to also verify the state of the alarm, breaking of a glass must be faked with mechanisms or use the appropriate test device..

This device has a microphone which is sensible to acoustic frequencies typically heard by the breaking of glasses, porcelains and similar materials. In addition to an intrusion alarm, Glass-Break detector reports tampering as it occurs, its operating conditions (supervision) and checks battery levels every 40 minutes. The control panel reports these signals following any arming and/or disarming operations.

Local signals
This device has an alarm/test LED, which also signals low battery, by quickly flashing for a few seconds.